HUNTER-PRO 32 Intruder Alarm System - Installation Manual
43
Connect MIC-100’s (-) and (+) to the detectors’ power source.
Voice
Unit
VU-20
TR(+)
JP5
Z5 Z6 Z7 Z8
-
+
KEY
-
S1 S2
SIREN
F3
F2
TMPR
2
TMPR
1
ON/
OFF
ALARM
OUT
F4
T1
yellow
blue
GND(-)
V(+)
red
black
AUDIO
Control Panel
LINE SET
AUD
CONT
IN OUT
Drawing 18-connecting VU-20 to control panel
3.16
Connecting Battery
The HUNTER-PRO 32 incorporates a rechargeable 12V backup battery. The
charging voltage for the battery is 13.8 V.
The system performs two battery tests as well as a manual test:
“Low level” test”: A continuous monitoring for battery failures such
as a disconnected wire, poor contact, etc.
“Under load” test”: Checks the battery capacity. This test is
conducted in the following cases:
Each time the system is armed.
Every day at 24:00.
Upon applying power to the system.
NOTE:
If the "under load" test fails, the system will respond as programmed in the
failure responses (sounding sirens, dialing the Monitoring Station, etc.).
Manual battery test: Enter the Master Code then press and hold the
key for a complete system check that also includes a battery
check.
To Next Page
Loading...
