Pima Hunter-Pro 32 - Programming Outputs; Polarity; Output Cards; Programming the Entire System

HUNTER-PRO 32 Intruder Alarm System - Installation Manual
76
5.8 Programming Outputs
In this screen the system’s outputs are programmed.
5.8.1 Polarity
In this screen you program the manner in which each of the following outputs
operates:
7
ENTR
ENTR
ENTR
>Mark “+” or ““ under each parameter>
Output Configur.
ENTER/NEXT/END
Output Polarity
ENTER/NEXT/END
SKOA Polarity
++++ +=Positive
9
Par. Para. Full name Note
S Siren (+) When using DC siren, the output’s
polarity changes.
K Smoke output (+) Smoke when output is activated.
O ON/OFF output (+) ON/OFF output is activated.
A Alarm (+) Alarm output is activated.
5.8.2 Output Cards
7
ENTR ENTR
NEXT
ENTR
To forward/backwards zones
BACKNEXT
ENTR
To the next partition
Output Configur.
ENTER/NEXT/END
Output Card
ENTER/NEXT/END
12345678 <-Out #
--------Positive
Part. For Out 1
----------------
9
In this screen OUT-1000’s outputs are allocated to partitions 1 to 16. when
there is an alarm from one of the partitions allocated to a certain outputs, the
output will be activated. This way, it is possible to activate separate sirens for
the different partitions, activate blinkers, and so on.
5.9 Programming the Entire System
This menu is for uploading the system with parameters configured in COMAX
and-or reset the system back to defaults.