Pima Hunter-Pro 32 - Remote-Controlling Via Telephone

HUNTER-PRO 32 Intruder Alarm System - Installation Manual
81
5.12 Remote-Controlling via Telephone
The system can be controlled from afar using any dial-tone telephone,
including cellular phone. It is possible to control the system once the
communication between the system and the telephone has been established.
 The communication can be initiated either by the system calling the
telephone, or manually by the user:
 Dial the telephone number the system is connected to
 Wait for the system’s confirmation tone (long continuous tone and two
beeps)
 Wait until the confirmation tone is over
 Enter the master code
 Wait for a few seconds until the system produces a confirmation sound
using one of the following two:
Continuous tone System disarmed
Segmented tone
System armed
NOTE:
The system will not receive orders from the telephone before the
confirmation sound is over.
From this moment the system can be controlled via telephone. After each
telephone key press, the system will confirm with two short beeps. After
the confirmation beeps, the further telephone keys can be pressed for
further operations:
Key [1] Arming the system
Key [2] Disarming the system
Key [4] Arming the system to HOME1
Key [5] Relay ON
Key [6] Relay OFF
Key [7] Arming the system to HOME2
Key [8] Microphone ON for one minute. Each further press of this key during
this minute prolongs it in one minute