HUNTER-PRO 32 Intruder Alarm System - Installation Manual
86
“
Other keypad in use
”. This message appears also when the
system is being programmed from a different source such as remote
programming via computer and telephone.
7.3 Solutions
7.3.1 Clock
This failure appears after initial connection to Power such as first time
operation or operation after AC and battery backup failure.
Solution:
Update time and date (refer to section. 2.2.12 and 2.18).
7.3.2 Battery
Battery failure indicates low battery power and appears after battery test and
after a pro–longed AC failure. (Refer to section. 2.16).
Solution:
Make sure battery fuse is intact.
Verify charging voltage.
Wait 24 hours for the failure message to disappear.
Replace the battery if the failure persists for a couple of days.
7.3.3 Low DC
Indicates a very low DC supply to the PCB. This failure is a result of a
prolonged AC failure that drains the backup battery. During this failure you can
not change any system parameters.
Solution:
Connect AC.
If necessary, replace battery.
To Next Page
Loading...
