Pima Hunter-Pro 32 - Wire Expenders; Local Expansion; Remote Expenders

HUNTER-PRO 32 Intruder Alarm System - Installation Manual
54
In this screen it is possible to program the system supporter’s name and phone
number.
Press and hold the
key in order to view the entered information (this
feature is possible only when the system is in OFF mode).
In order to see how to enter names (letters and digits), turn to Chapter 8:
“Name Programming”.
5.2.2 Wire Expenders
ENTR
1
Expanders
ENTER/NEXT/END
ENTRNEXT
Sys Installation
ENTER/NEXT/END
9
In this screen you program the type of Wire Expenders installed in the system.
5.2.2.1 Local Expansion
XM
_-
NEXT BACK ENTR
The mark “+” under the “X” signifies that an 8-additional-zones local expender
is installed in the system (EXP-LOCAL).
NOTE:
It is not possible to simultaneously install in the system local expender and
zone doubling.
The mark “+” under the “M” signifies that zones 1 to 8 are regular zones while
zones 9 to 16 are doubled zones (using a resistor and a diode).
To change the mark from “-“ to “+” and vice versa use
key
To move backwards/forwards between “x” and “M use
and keys
To enter “X” and “M” parameters use
key
5.2.2.2 Remote Expenders