Figure 24-12. Testing Stator Figure 24-l3. Removal of Pulley
TESTING OF STATOR
l. Remove varnish from a spot on stator frame.
2. Press a test probe firmly onto bare spot.
3. Press other test probe firmly to each of three stator lead terminals one at a time. If lamp lights,
individual stator lead is grounded.
4. Prcss one test probe firmly on one stator lead and press other test probe firmly onto each of the other
two stator leads one at a time. The test lamp should light. If lamp fails to light, stator winding is open.
5. Should stator prove to bc grounded or open, replace stator.
REMOVAL OF PULLEY AND BEARING
—NOTE—
The pulley and bearing are installed on the rotor shaft with an
interference fit. It is suggested that Puller Tool C-4068 be used to
reduce possibility of damage to either pulley or bearing.
24 - 32 - 00
Page - 24 - 19
Reissued: August 1, 1986
1I18
PIPER AIRCRAFT
PA-28-236
MAINTENANCE MANUAL
To Next Page
Loading...
