MULTIPURPOSE ELECTRICAL AND ELECTRONIC PARTS
ELECTRICAL SWITCHES AND CIRCUIT BREAKERS
The switches are of the rocker type. The switches are mounted in the middle of the instrument panel. The
circuit breakers are single hole mounting, pushbutton type with manual reset; they must be reset when tripped.
The circuit breakers are on a panel on the lower nght hand corner of the instrument panel.
REMOVAL OF ELECTRICAL SWITCHES
1. For a particular switch removal, remove screw above and screw below switch on front of instrument
panel.
2. From behind instrument panel, remove switch, and disconnect electrical connections.
—NOTE—
Note placement of electrical leads to facilitate installation.
—END—
39 - 41 - 00
Page 39 - 01
Reissued: August 1, 1986
2E18
PIPER AIRCRAFT
PA-28-236
MAINTENANCE MANUAL
To Next Page
Loading...
