ROTATING BEACON
REMOVAL OF ROTATING BEACON
1. Loosen screw securing clamp around rotating beacon lens. Remove clamp and lens.
2. Remove light bulb from bayonet socket.
3. To remove complete rotating beacon assembly, proceed as follows:
a. Remove screws securing assembly to fin tip.
b. Pull rotating beacon assembly out and disconnect the electrical leads. Take note of their placement
to facilitate reinstallation.
INSTALLATION OF ROTATING BEACON
1. Install light bulb in bayonet socket.
2. Replace lens and clamp and secure by tightening screw on clamps.
ANTI-COLLISION LIGHT (STROBE)
WING TIP STROBE LIGHT
REMOVAL OF WING TIP STROBE LIGHT
l. Remove screw securing navigation light cover and remove cover.
2. Remove three screws securing navigation light bracket assembly and pull out.
3. Remove strobe lamp by cutting wires on lamp beneath mounting bracket.
4. Remove defective lamp.
5. Remove and discard plug with cut wires from its electrical socket.
INSTALLATION OF WING TIP STROBE LIGHT
l. Route wires from new lamp down through hole in navigation light bracket.
2. Insert wire terminals in plastic plug supplied with new lamp. Wire according to schematic diagram.
(Refer to figure 33-1.) Connect plug to receptacle.
3. Position strobe lamp on navigation light bracket.
4. Secure navigation light assembly and bracket with screws.
5. Install navigation light cover and secure with appropriate screw.
33 - 44 - 00
Page 33 - 06
Reissued: August 1, 1986
2D3
PIPER AIRCRAFT
PA-28-236
MAINTENANCE MANUAL
To Next Page
Loading...
