All-New Event Presentation Switching Solutions
User Manual
7 Event Management Software PixelFlow
Software Installation and Connection
7.1.1 Software Installation
Prerequisites
The software package is obtained.
A computer meeting the following requirements is prepared:
− Operating system: Windows 10 (64-bit) or later
− CPU: Intel® Core™ i5 or later
− RAM: 8 GB or greater
Installation Method
Run the .exe file and follow the setup wizard to complete the installation. If a firewall
prompt appears, choose to allow the installation.
Installation Result
After a successful installation, the PixelFlow software icon is displayed on the
desktop. Double-click this icon to open the PixelFlow software.
7.1.2 Software Connection
The PixelFlow software is installed on the control computer. The control computer
can connect to the device in the following two ways:
Via Ethernet cable
Connect the device and the control PC directly via Ethernet cable and set a static
IP address for the device to let it and the control PC be on the same network
segment.
Via LAN
Connect the device and the control PC to the same LAN via a router and set the
device to automatically obtain an IP address.
Notes
The device in this chapter refers to the P20, P10 or Q8 seamless switcher.
The software pictures given in this chapter are used for illustration purposes
only. The actual user interface may vary slightly due to product enhancement.
The content of the pictures can be slightly different from reality, such as the
form and position of the software windows, input source images and more.
To Next Page
Loading...