PIXELHUE P20 - Network Settings

All-New Event Presentation Switching Solutions
User Manual
6 Menu Operations
www.pixelhue.com
101
No.
Content
Description
5
Control card
connector
Show the control card connector status.

Green: The connector is connected and works normally.

White connector: The connector is not connected or works
abnormally.
6
Voltage
status
Show the device working voltage status.

Normal: The voltage of each module in the device is normal.

Abnormal: The voltage of one or some modules in the device
is abnormal, and the device needs troubleshooting.
7
Temperature
status
Show the device working temperature status.

Normal: The temperature of each module in the device is
normal.

Abnormal: The temperature of one or some modules in the
device is too high, and the device needs troubleshooting.
8
Fan status
Indicate whether the fan speed is normal when the device is
working.

Normal: The speed of each fan in the device is normal.

Abnormal: The speed of one or some fans in the device is
abnormal, and the device needs troubleshooting.
9
Settings
Click to enter the device menu where you can perform the
following device operations.

Network settings: Configure the device IP address.

Device information: Check the device’s chassis and card
version, and fan status.

Advanced settings: Perform factory reset settings, firmware
update, project file import and export, log export, and AC back
settings for the device.

About us: Check the official website and technical support
email address of the device manufacturer.
6.2.3 Network Settings
On the home screen, tap located at the bottom right corner to enter the settings
screen.
Select Network to enter the network settings screen.
Configure the device IP address information.