PIXELHUE P20 - Configure Output Properties

All-New Event Presentation Switching Solutions
User Manual
7 Event Management Software PixelFlow
www.pixelhue.com
134
Type
Parameter
Description
Gain
The hue softness of the transition area
The larger the value, the softer the transition.
Foreground
Color
Turn on or turn off the function.

: On. After the function is turned on, the
associated parameter Color can be used to adjust
the keying effect.

: Off
Color
The RGB values of the foreground color
Chroma key
parameters
Pick
The RGB values of the pick point

Config method 1: Click Pick, and then click the
position to be picked in the input source image.

Config method 2: Set the coordinates of the pick
point in the input source image.

Config method 3: Set the RGB values of Background
Point.
After the settings, click Apply. You can also adjust the
following parameters to optimize the keying effect.
Hue Ramp
To distinguish between the foreground and
background
Hue Clip
The hue range
The larger the value, the larger the removal area. The
maximum value is the current value of Hue Ramp.
Saturation
Clip
To distinguish between the foreground and
background
Gain
The hue softness of the transition area
The larger the value, the softer the transition.
Spill
To remove the overflow from the foreground image
edges and semi-transparent areas
Shadow
To remove the shadow areas
Highlight
To remove the highlight areas
Edge Smooth
Turn on or turn off the function.

: On

: Off
7.3.4 Configure Output Properties
Click the target output connector on the graphical device rear panel, and then set the
output-related properties in the property area on the right pane.