All-New Event Presentation Switching Solutions
User Manual
device and the grounding point respectively, which means
that the device must be grounded through the grounding
point to ensure the normal operation of the device and the
personal safety of the operators.
Sensitive electronic device
Keep the device away from areas with strong
electromagnetic radiation to avoid electromagnetic
interference and thus affect the image output quality.
Device carrying
The device needs to be carried by multiple people.
Removing cards
Remove cards before taking out the motherboard.
Notes and Cautions
2.8.1 Installation Notes
When the product needs to be installed on the rack, 4 screws (M5*12) should be
used to fix P20/P10 and 16 screws (M5*12) should be used to fix Q8. The rack for
installation shall bear at least four times the total weight of the mounted equipment.
a) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly,
the operating ambient temperature of the rack environment may be greater than
room ambient. Therefore, consideration should be given to installing the
equipment in an environment compatible with the maximum ambient
temperature (Tma) specified by the manufacturer.
b) Reduced Air Flow - Installation of the equipment in a rack should be such that
the amount of air flow required for safe operation of the equipment is not
compromised.
c) Mechanical Loading - Mounting of the equipment in the rack should be such that
a hazardous condition is not achieved due to uneven mechanical loading.
d) Circuit Overloading - Consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be used when addressing
this concern.
e) Reliable Earthing - Reliable earthing of rack-mounted equipment should be
maintained. Particular attention should be given to supply connections other
than direct connections to the branch circuit (e.g. use of power strips).
2.8.2 FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
To Next Page
Loading...