All-New Event Presentation Switching Solutions
User Manual
E Earth N Neutral L Live
2.4.2 Signal Cables
Before using a DVI signal cable, check whether the pins on the cable connector
are vertical and even. If not, please replace the cable.
Before connecting the signal cable to the device, check whether there is any
object in the device connector. If yes, remove the object first.
If the signal cable has not been used for a long time, discharge static electricity
before using it.
Under normal working conditions of the device, it is recommended that non-
technical professionals do not perform hot-swapping to avoid device damage.
2.4.3 Miscellaneous
Signal cables must be bound separately from strong current cables or high
voltage cables.
When the temperature is too low, severe shock and vibration may cause brittle
cracking of the plastic sheath of the cable. All cables should be laid and installed
when the temperature is above zero.
If the storage temperature of the cable is below zero, the cable must be moved to
room temperature and stored for more than 24 hours before laying and
installation.
When carrying cables, especially in a low-temperature environment, always handle
the cable with care. Violent handling, such as pushing down the cables directly
from a high place, is prohibited.
Electrical Safety
2.5.1 Battery
The battery is not intended to be replaced.
Always follow the relevant instructions to dispose of batteries.
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of
a battery can result in an explosion.
Leaving a battery in an extremely high temperature surrounding environment can
result in an explosion or the leakage of flammable liquid or gas.
A battery subjected to extremely low air pressure may result in an explosion or the
leakage of flammable liquid or gas.
To Next Page
Loading...