All-New Event Presentation Switching Solutions
User Manual
Do not step on, hit and violently operate the device and its packaging to prevent
damage to the device or packaging box.
Do not block the ventilation openings during operation.
Tighten the board or card screws with a tool.
After the installation, remove the empty packing materials from the device area.
Save the packing box and materials for possible storage and transportation in the
future.
Always wear anti-static wrist bands and insulating gloves when touching the
static-sensitive components.
Avoid dropping any object into the chassis.
Keep the device away from conductors that are easy to induce lightning to avoid
lightning strikes to the device.
Do not make the circuit faces of the boards or cards contact each other.
Do not touch the circuit, components, connectors or wiring slots of the boards or
cards with bare hands.
Do not repair the device without authorization. Only trained professionals can
maintain the device. You can contact PIXELHUE at any time if needed.
Always use the spare parts recommended by PIXELHUE.
Regularly clean the dust on the heat dissipation holes to prevent the dust from
blocking the holes and thus affect the heat dissipation of the device.
2.1.4 Personal Safety
Place the device in a stable location to prevent personal injury caused by falling.
Avoid bare wires and maintain or replace them in time when they are damaged.
Do not operate the device and connect cables outdoors under thunderstorms.
Do not wear watches, rings, or other metal jewelry when installing spare parts or
maintaining the device.
Device Carrying
Do not relocate a powered device, and do not take any objects that may cause
danger to the relocation.
Always pay attention to the wheels at the bottom of the flight case during
transportation to avoid them being jammed by stones or deformed due to external
forces.
Always hold the handles of the flight case firmly when pushing a flight case with
wheels. Do not stack other devices on the flight case.
The relocated device should be repacked in the original factory packaging.
Do not disassemble the components during the transportation of the flight case.
When handling or placing the boards or cards, bare board components or
modules, always package them individually.
To Next Page
Loading...