Planet WGSW-404 - Stacking; Stacking Basic Setting

- 132 -
Trap.
30. When you finish, press the Esc key until you return to the desired screen.
5.11 Stacking
Select Stacking from the Advanced Management screen to configure the stacking function. You will
receive a Stacking screen as shown in the following.
F
IGURE
5-105 S
TACKING
S
CREEN
Stacking Basic Setting enables you to set stack ID, stack size, and stack port. Stack IP Settings lets
you to set the IP address of the stacked switches. Stack Port Mapping shows information about all
ports.
5.11.1 Stacking Basic Setting
Select Stack Basic Setting from the Stacking screen and press Enter. The following screen will appear.