- 18 -
3.3 SNMP-Based Network Management
You can use an external SNMP-based application to configure and manage the Switch. This
management method requires the SNMP agent on the Switch and the SNMP Network Management
Station to use the same community string. This management method, in fact, uses two community
strings: the get community string and the set community string. If the SNMP network management
station only knows the set community string, it can read and write to the MIBs. However, if it only knows
the get community string, it can only read MIBs. The default gets and sets community strings for the
Switch are public.
3.4 Protocols
The Switch supports the following protocols:
 Virtual terminal protocols, such as Telnet
 Simple Network Management Protocol (SNMP)
3.4.1 Virtual Terminal Protocols
A virtual terminal protocol is a software program, such as Telnet, that allows you to establish a
management session from a Macintosh, a PC, or a UNIX workstation. Because Telnet runs over
TCP/IP, you must have at least one IP address configured on the Switch before you can establish
access to it with a virtual terminal protocol.
Note: Terminal emulation differs from a virtual terminal protocol in that you must connect a terminal
directly to the console (serial) port.
3.4.2 SNMP Protocol
Simple Network Management Protocol (SNMP) is the standard management protocol for multi-vendor
IP networks. SNMP supports transaction-based queries that allow the protocol to format messages and
to transmit information between reporting devices and data-collection programs. SNMP runs on top of
the User Datagram Protocol (UDP), offering a connectionless-mode service.
To Next Page
Loading...
Need help?
General
