- 104 -
10. When you finish specifying the ping parameters, press Esc start pinging a remote IP address.
11. Press Esc again until the IP Networking screen appears.
5.7 Bridging
If you select Bridging from the Advanced Management screen, the following Bridging Parameters
screen appears.
F
IGURE
5-71
1. To change the MAC address table aging time, highlight Aging Time (seconds) and press Enter.
The following prompt asks you to either set an aging time or select no aging. (The maximum
number is 1,000,000 seconds)
To Next Page
Loading...
