Planet WGSW-404 - Specifying a SLIP Address

- 45 -
F
IGURE
4-27
If you enable SLIP, specify a SLIP address and subnet mask (see “Specifying a SLIP Address” and
“Specifying a SLIP Sub-net Mask”).
4.3.3.6 Specifying a SLIP Address
If you enabled SLIP, use the following procedure to enter an address that has a network part different
than the network address of the Switch. (For more information, contact your network administrator.)
1. From the Console Port Configurations screen, highlight SLIP Address and press Enter. The
following screen appears.