Planet WGSW-404 User Manual

- 202 -
page 5.
 Reboot — lets you reboot the Switch. When you click this option, a message asks whether you
want to reboot the Switch. Click OK to reboot the Switch or Cancel to not reboot it.
 Logout — lets you log out of the configuration program. When you click this option, a message
asks whether you are sure you want to log out. Click OK to log out or Cancel to continue your
session.
6.3.1 Receiving Files via TFTP
The TFTP protocol is used to download upgraded software to the Switch. A VLAN with the proper IP
address and routing path to the TFTP server must be configured for the Switch to access the specified
TFTP server.
The following procedure describes how to receive files using the TFTP protocol.
1. Point to File and click Receive File Via TFTP. The Receive File Via TFTP window appears (see
Figure 6-5).
F
IGURE
6-5 R
ECEIVE
F
ILE
V
IA
TFTP W
INDOW
2. For File Name, type the name of the file you intend to receive.
3. For IP Address, type the IP address from where the file will be obtained. The address consists of
numbers separated by periods. For example: 129.32.0.11
4. Click Receive Now!

Planet WGSW-404 Specifications

General

Brand	Planet
Model	WGSW-404
Category	Network Router
Language	English