Planet WGSW-404 - ARP Table Setting; Adding Static ARP Table Entries

- 87 -
5.6.2 ARP Table Setting
If you select ARP Table from the IP Networking screen in Figure 5-47, an ARP Table screen similar to
the following appears with the ARP table entries that have been already defined or learned.
F
IGURE
5-47
From this screen, you can:
 Add static entries to the ARP table. See section 5.6.2.1 “Adding Static ARP Table Entries”.
 Delete static entries from the ARP table. See section 5.6.2.2 “Deleting Static ARP Table Entries”.
 Search for entries in the ARP table. See section 5.6.2.3 “Searching for ARP Table Entries”.
5.6.2.1 Adding Static ARP Table Entries
To add static entries to the ARP table:
1. From the ARP Table screen, hold down the Shift key and press +. The Static ARP Specifications
screen appears, with the highlight in the Internet Address field.