- 204 -
F
IGURE
6-7
B
ASIC
S
ETUP
/G
ENERAL
P
ARAMETERS
The Basic Setup/General parameters have the following read-only fields:
 Hardware Revision — shows the revision of the Switch’s hardware.
 Hardware Configuration — shows the Switch’s hardware configuration.
 Software Revision — shows the revision of the Switch’s software.
Below these fields are two text boxes and three drop-down lists where you can specify the following
information.
1. To change the system name, click in System Name and replace the current name shown with a
new one.
2. To change the location name, click in Location and enter a location name.
3. To enable or disable statistics collection at the Switch, click the appropriate option from the
Statistic Collection drop-down list.
4. To allow or prevent the Switch from rebooting when a fatal error is detected, click the appropriate
option from the Reboot-On-Error dropdown list.
5. To enable or disable access to the Switch management program via Telnet, click the appropriate
option from the Remote Telnet Login drop-down list.
6. Click the Update Setting button to save your settings.
To Next Page
Loading...
Need help?
General
