- 236 -
F
IG
7-29
Note: If IGMP is disabled or no IP Multicast group is learned, the table will be empty. To enable IGMP,
Click Advanced Setup and then select other protocol to set IGMP to either Passive or Active.
2. Click the IP Multicast Group to view activities on the group. A screen similar to the following
appears.
F
IG
7-30
3. To view the VLAN and IP multicast group addresses associated with the MAC address, Click the
MAC address, a VLAN/IP Multicast Group Membership screen similar to the following appears.
To Next Page
