CIRAS-3 Operation Manual V. 1.09 152 support@ppsystems.com
In the lower left hand corner of the display (status bar), you will see the following:
M Record xx saved to file: C30008_20130611_01.xml
Data is output every 1.6 seconds during the measurement sequence and saved to the file that is
displayed. At the end of a measurement sequence during manual recording, a message “Sequence
complete. Press F6 to start a new sequence.” appears in the status bar. Additional measurements can
be recorded by pressing Begin CPY/SRC (F6) and to end recording, press End Recording (F5).
To Next Page
Loading...
