CIRAS-3 Operation Manual V. 1.09 79 support@ppsystems.com
Controls (F3)
Controls allow you to dynamically change many of the default options you have made previously under
Settings without reverting the system back to its initial set of values in the Settings dialog. Use Controls
to establish system stability (empty leaf chamber) by altering CO
2
, H
2
O, light factors, temperature, flow
rate and leaf area. Press Controls (F3) to enter control mode and make changes then press Accept
(F2). The status bar in the lower left corner will display the message “Updating Environmental Control
values…” and the plot data displayed in Graph View will refresh.
To Next Page
Loading...
