Configuring a Hotspot
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|130
To define a network interface for a Hotspot:
1. Click Configure in Local Network.
The Local Network window opens.
2. Select interface and click Edit.
The Edit <interface> window opens.
3. Select Use Hotspot.
4. Click Apply
Any user that browses from configured interfaces is redirected to the Check Point
Hotspot portal.
After you define a network interface for the hotspot, you can configure:
n
Guest access - A session is created for an IP address when a user accepts terms or
authenticates in the Hotspot portal. The session expires after the configured timeout
(240 minutes by default).
n
Customize the Hotspot portal appearance.
1. Click Customize Hotspot portal.
2. For Portal title - Keep the default or enter a different title.
3. For Portal message - Keep the default or enter a different message.
4. For Terms of use - Select this checkbox to add an "I agree with the following
terms and conditions" checkbox on the Hotspot portal page. Enter the terms and
conditions text in the text box. When users click the "terms and conditions" link,
this text shows.
5. To customize a logo for all portals shown by the appliance (Hotspot and captive
portal used by User Awareness), click Upload, browse to the logo file and click
Apply. If necessary, click Use Default to revert to the default logo.
6. Click Apply
n
Hotspot exceptions
Define specified IP addresses, IP ranges or networks to exclude from the Hotspot.
1. Click Manage Exceptions.
The Manage Hotspot Network Objects Exceptions window opens.
2. Select the objects to add as exceptions.
To Next Page
Loading...
