Configuring the QoS Policy
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|266
Configuring the QoS Policy
In the Access Policy view > QoS section > Policy page you can configure the manual QoS
policy rules.
The top of the page shows information about these limits:
n
Bandwidth Consuming Applications - If you set download and upload rates in the
Access Policy > QoS Blade Control page or Access Policy > Firewall Blade Control
page. If you see the disabled link, click it to configure the rates here.
n
Low latency traffic - Shows the maximum percentage of bandwidth that can be reserved
for low latency traffic. If you do not set a maximum percentage, traffic that does not
require low latency might be starved (might not be handled at all). To change the value,
click the percentage link.
You can view the QoS Policy Rule Base on this page. For each rule, you see these fields:
Rule Base Field Description
No. Rule number in the QoS policy.
Source Network object that starts the connection.
Destination Network object that completes the connection.
Service Type of network service for which bandwidth is adjusted based on
weight, limit, and guarantee.
Guarantee/Limit Lets you set a percentage that limits the bandwidth rate of traffic
and/or guarantees the minimum bandwidth for traffic. Another option
is to mark the traffic as low latency. This guarantees that it is
prioritized accordingly.
Weight The unit used to divide available bandwidth when traffic exceeds the
maximum bandwidth configured for the Internet connection. See
below.
Track The tracking and logging action that is done when traffic matches the
rule.
Comment An optional field that shows a comment if you entered one. For
system generated rules of the default policy a Note is shown.
To Next Page
Loading...
