Advanced Settings
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|208
Clarifications
This section contains clarifications for specific attributes.
Attribute Name Note
Two-Factor
Authentication - Enable
selection of target
where to send the
passcode (SMS/email)
1. Select or clear the checkbox:
n
Cleared - The appliance sends the OTP by SMS and
by Email (this is the default).
n
Selected - After an end-user clicks "Connect" in their
Remote Access VPN client, in the next window the
end-user must enter a mobile phone number to get
the OTP by SMS, or enter an email to get the OTP by
Email.
2. Click Apply
Note - This setting does not affect the selection screen in
the WebUI on the VPN Remote Access Control page. The
user must still configure to receive the passcode through
email, SMS, or both options.
All attributes, whose
name starts with "DSL
globals"
When all the ADSL standards are turned off in the Advanced
Settings, and you can only connect using the VDSL2 standard,
the VPI, the VCI, and the encapsulation options still appear,
even though they are not used to open an Internet connection.
Changes Between Versions
This section describes changes in attributes in different R81.10.X versions.
Attribute Name Supported Versions
OS advanced settings - Default routes rank R81.10.10 and Higher
Dr. Spark job R81.10.08 and Higher
Fonic settings - Mode R81.10.08 and Higher
OS advanced settings - Enable automatic WiFi
channel change
R81.10.08 and higher
OS advanced settings - Enable GPS R81.10.07 and higher
OS advanced settings - Enable Jumbo Frames R81.10.07 and higher
USB Modem Watchdog - Enabled by Default R81.10.05 and higher
To Next Page
Loading...
