Configuring DDNS and Access Service
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|163
To register to the Reach My Device service:
1. Click Register.
The Reach My Device window opens.
2. For Host Name, use the default host name or enter a name for this appliance to enable
remote access.
3. If the host name was already defined, select Register with an existing homename and
enter the Validation token of the gateway. This token verifies that an existing name
belongs to this appliance owner.
4. Click Apply
The validation token, web link, and shell link are shown on the page.
5. Go to Device > Administrator Access. Configure Internet as a source for administrator
access and Set specified IP addresses.
When the gateway participates in VPN, you can exclude the WAN interface (or any other
interface used for the Internet connection) from the encryption domain and use Reach My
Device traffic without a VPN tunnel.
In the VPN Site to Site global settings Advanced Setting, enable Do not encrypt
connections originating from the local gateway.
How to access the gateway with the Reach My Device service:
When registration is complete, an outgoing tunnel to the Check Point Cloud Service is
established with the appliance's IP address.
Remote Access to the WebUI
Web Link - Use this URL in a browser to remotely access the appliance.
For example: https://mygateway-web.smbrelay.checkpoint.com
Enter the applicable user name and password.
Remote Access to the CLI
Shell Link - Use this URL in a browser to open an SSH connection to the appliance to use CLI
commands.
For example: https://mygateway-shell.smbrelay.checkpoint.com
Enter the administrator credentials.
To Next Page
Loading...
