Configuring Local and Remote System Administrators
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|148
Remote Administrators
Note - In R81.10.10, Two-Factor Authentication is not supported when RADIUS or
TACACS is configured for administrator access.
To allow access for administrators defined in a remote RADIUS server:
1. Make sure administrators are defined in the remote RADIUS server.
2. Make sure a RADIUS server is defined on the appliance. If there is no server, click the
RADIUS configuration link at the top of this page. You must configure the IP address
and shared secret used by the RADIUS server.
3. When you have a configured RADIUS server, click Edit permissions.
The RADIUS Authentication window opens.
4. Select Enable RADIUS authentication for administrators.
Use roles defined on RADIUS server is selected by default.
5. Configure the role for each user on the RADIUS server. See additional details below.
Note - A user without role definition will get a login error.
6. If you select Use default role for RADIUS users, select the Administrators Role:
n
Super Admin
n
Read only
n
Networking Admin
n
Mobile Admin
7. To define groups, click Use specific RADIUS groups only and enter the RADIUS
groups separated by a comma.
8. Click Apply
To Next Page
Loading...
