Managing the Device
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|74
Managing the Device
This section describes how to set up and manage your Quantum Spark Appliance.
Configuring Internet Connectivity
The Device view > Network section > Internet page shows how the appliance connects to the
Internet.
On this page you can:
n
Add new IPv6 and IPv4 connections and edit, delete, or disable existing connections.
Note - Only one IPv6 connection can exist at a time.
n
Configure a single Internet connection or multiple connections in High Availability or
Load Sharing configurations. When multiple Internet connections are defined, the page
shows them in a table.
n
Monitor the servers and Internet connections (see
"Monitoring" on page97
).
We recommend you contact your local Internet Service Provider (ISP) to understand how to
configure your specific Internet connection.
Note - ADSL/VDSL settings are relevant only for devices that have a DSL port. In
1570 / 1590 appliances, you can also configure a DSL connection over the DMZ port
(see
"To configure an Internet connection over the DMZ port:" on page85
).
Getting Started
1. Connect with WebUI on the Quantum Spark Appliance at this address:
https://<IP Address>:4434
2. Go to Device view > Network section > Internet page.
3. Configure an Internet connection.
a. Click New or Add an IPv4 Internet connection.
The New Internet Connection window opens.
b. Configure the required setting on the Configuration tab:
To Next Page
Loading...
