Configuring External Log Servers
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|412
To configure a new external Check Point Log Server when the gateway is connected to
Quantum Spark Portal (Cloud):
After you initiate traffic from resources behind the gateway, open the Check Point Log Server
to verify that you see the logs. For more information, see sk145614.
Syslog Server Configuration
You can configure a gateway to send logs to multiple syslog servers. - Only one secure syslog
server is supported.
To configure a syslog server:
1. Under Syslog Servers, click Configure.
The Syslog Server window opens.
2. Select Protocol:
n
UDP - Send security logs or system logs (not secured).
n
TLS Over TCP (secured) - Send system or security logs from gateways in a
secured and encrypted fashion.
3. Enter a Name and IP address/ Host Name.
4. Enter a Port number.
5. Select Enable log server.
6. Optional - Select Show obfuscated fields. Obfuscated packets are shown as plain text.
7. Select Forwarded logs:
n
System logs
n
Security logs
8. Click Upload to upload a Trusted CA Certificate.
9. Click Apply
To Next Page
Loading...
