Configuring the Anti-Spam Blade Control
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|297
Configuring the Anti-Spam Blade Control
In the Threat Prevention > Anti-Spam Blade Control page you can activate the Anti-Spam
engine to block or flag emails that contain known or suspected spam content.
Select to inspect based on:
n
The sender's source address.
n
The email content.
Use the logs to understand if your system is experiencing spam attacks.
You can handle suspected spam the same way as known spam, or select to handle suspected
spam separately (see below).
To enable or disable Anti-Spam:
1. Select On or Off.
2. Click Apply
Note - When the blade is managed by Cloud Services, a lock icon is shown. You
cannot toggle between the on and off states. If you change other policy settings, the
change is temporary. Any changes made locally will be overridden in the next
synchronization between the gateway and Cloud Services.
To configure Detect-only mode:
In Detect-only mode, logs appear but the blade does not block any emails.
1. Select the Detect-only mode checkbox.
2. Click Apply
To Next Page
Loading...
