Quantum SPARK 1500 - Pairing a Mobile Device

Configuring Local and Remote System Administrators
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|149
To set the Session Timeout value for both local and remotely defined administrators:
1. Click Security Settings.
The Administrators Security Settings window opens.
2. Configure the session timeout (maximum time period of inactivity in minutes). The
maximum value is 999 minutes.
3. To limit login failure attempts, click the Limit administrators login failure attempts
checkbox.
4. Enter the number of Maximum consecutive login attempts allowed before an
administrator is locked out.
5. In Lock period, enter the time (in seconds) that must pass before a locked out
administrator can attempt to log in again.
6. To enforce password complexity on administrators, click the checkbox and enter the
number of days for the password to expire.
Note - We strongly recommend the use of complex passwords. Password
must contain at least 12 characters - uppercase, lowercase, numeric, and
non-alphanumeric characters. Allowed alphanumeric characters: ! @ # %
^ & * ( ) - _ + : ;
7. Click Apply
Pairing a Mobile Device
To connect the mobile application with the appliance for the first time:
1. Click Mobile Pairing Code.
The Connect Mobile Device window opens.
2. Select an administrator from the pull down menu.
3. Click Generate.
This generates a QR code to connect the Check Point WatchTower mobile application
with the appliance for the first time.
For more information about the mobile application, see the WatchTower App User Guide .