Managing Internal Certificates
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|205
Upgrading a Cluster Manually
Procedure
Notes:
1. Only manual local upgrade is supported.
2. Upgrade each Cluster Member individually.
3. Start the upgrade on the Standby Cluster Member.
4. After the upgrade, the appliance automatically reboots and changes its
cluster state to Active.
5. Start the upgrade on the new Standby Cluster Member (former Active).
1. Upgrade the current Standby Cluster Member:
a. Connect to the WebUI on a Cluster Member:
https://<IP Address of the Cluster Member>:4434
b. From the left navigation panel, click Device.
c. In the Advanced section, click the High Availability page.
d. At the top of this page, examine the cluster state.
If the current cluster state shows "This gateway (<...>) is standby", then
continue to the next step.
Otherwise, connect to the other Cluster Member
e. In the System section, click the System Operations page.
f. Click Manual Upgrade.
The Upgrade Software Wizard opens.
g. Follow the wizard instructions.
h. Standby Cluster Member reboots automatically and changes its cluster state to
Active.
2. Upgrade the new Standby Cluster Member (former Active Cluster Member):
a. Connect to the WebUI on the Cluster Member:
https://<IP Address of the High Availability>:4434
b. From the left navigation panel, click Device.
c. In the Advanced section, click the High Availability page.
To Next Page
Loading...
