Quantum SPARK 1500 - Backup, Restore, Upgrade, and Other System Operations

Backup, Restore, Upgrade, and Other System Operations
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|138
Backup, Restore, Upgrade, and Other System
Operations
In the Device > System Operations page you can:
n
Reboot
n
Restore factory default settings.
n
Revert to the factory default image and settings.
n
Automatically or manually upgrade the appliance firmware to the latest Check Point
version.
n
Revert to earlier firmware image.
n
Backup appliance settings to a file stored on your desktop computer.
n
Restore a backed up configuration.
n
Enable IPv6 networking and enforce IPv6 security.
To reboot the appliance:
1. Click Reboot.
2. Click OK in the confirmation message.
To restore factory default settings:
1. Click Default Settings.
2. Click OK in the confirmation message.
The factory default settings are restored. The appliance reboots to complete the
operation.
Note - This does not change the software image. Only the settings are restored
to their default values (IP address 192.168.1.1, WebUI address
https://192.168.1.1:4434, the username admin and the password
admin).