Quantum SPARK 1500 - L2 TP VPN Client Configuration; Configuring Site to Site VPN with a Preshared Secret; Introduction; Prerequisites

Configuring VPN
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|305
L2TP VPN Client configuration
For L2TP VPN Client configuration, click L2TP Pre-shared key to enter the key after you
enable the L2TP VPN client method.
Advanced Options
For more information on advanced Remote Access options, for example Office Mode network,
see "Configuring Advanced Remote Access Options" on page333 .
Monitoring
To make sure Remote Access is working:
Use the configured client to connect to an internal resource from a remote host.
Configuring Site to Site VPN with a Preshared Secret
Introduction
In this Site to Site VPN configuration method a preshared secret is used for authentication.
Prerequisites
n
Make sure the Site to Site VPN blade is set to On and Allow traffic from remote sites (by
default) is selected. See "Configuring the Site to Site VPN Blade" on page337 .
n
The peer device that you connect to must be configured and connected to the network. If
it is a DAIP gateway, its host name must be resolvable.
Configuration
Enter a host name or IP address and enter the preshared secret information. For more
information, see "Configuring VPN Sites" on page340 .
Monitoring
To make sure the VPN is working:
1. Send traffic between the local and peer gateway.
2. Go to VPN > VPN Tunnels to monitor the tunnel status. See "Viewing VPN Tunnels" on
page350 .