Managing Internal Certificates
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|204
Changing Network Configuration of Cluster Members
Procedure
1. Reset the cluster configuration on the secondary Cluster Member.
See
"Resetting Cluster Configuration" below
.
2. On the primary Cluster Member, change the configuration.
3. On the primary Cluster Member, click Reinitialize Trust.
4. Reconnect the secondary Cluster Member, which fetches the new configuration.
Resetting Cluster Configuration
Procedure
1. Connect to the WebUI on one of the Cluster Members:
https://<IP Address of the Cluster Member>:4434
2. From the left navigation panel, click Device.
3. In the Advanced section, click the High Availability page.
4. Click Reset Cluster Configuration.
Important - This deletes all cluster configuration settings from both Cluster
Members. You must run the New Cluster Wizard again to configure the cluster.
To Next Page
Loading...
