Quantum SPARK 1500 - Threat Prevention - Horizon SOC

Configuring Threat Prevention Policy Exceptions
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|283
To edit or delete an exception rule:
1. Select the relevant rule.
2. Click Edit or Delete.
Threat Prevention - Horizon SOC
The Check Point Horizon SOC is supported from R81.10.00 in the Locally Managed mode.
Horizon SOC enables cybersecurity teams to effectively and efficiently prevent, detect and
respond to all threats. Horizon SOC doubles the effectiveness of SOC teams by automating
time-consuming tasks, allowing security teams to focus on remediation and attack prevention.
You can enable the Horizon SOC feature in the WebUI or through Gaia Clish commands.
To enable the Horizon SOC feature in the WebUI:
1. Click Device > Advanced Settings.
2. In the Privacy Settings Attribute section, select the attribute Help Check Point improve
its products by sending data.
a. Click Edit.
b. Select Help us improve product experience by sending data to Check Point.
c. Click Apply
3. In the Threat Prevention Policy Attribute section, select the attribute Allow me to view
attack statistics in my User Center account.
a. Click Edit.
b. Select Allow me to view attack statistics in my User Center Account.
c. Click Apply
4. Optional: In the Threat Prevention Policy section, select the attribute Allow IP address
information in attack statistics.
a. Click Edit.
b. Select Allow IP address information in attack statistics.
c. Click Apply