Quantum SPARK 1500 - The Home Tab; Viewing System Information

The Home Tab
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|37
The Home Tab
This chapter describes the Home tab of the WebUI application.
Viewing System Information
The Home > System page shows an overview of the Quantum Spark Appliance.
The Quantum Spark Appliance requires only minimal user input of basic configuration
elements, such as IP addresses, routing information, and blade configuration. The initial
configuration of the Quantum Spark Appliance can be done through a First Time Configuration
Wizard. When initial configuration is completed, every entry that uses http://my.firewall
shows the WebUI Home > System page.
n
System Information - Shows the appliance model, installed software version, name,
MAC address, system date and time (with the GMT setting), and system uptime.
n
Notifications - Shows events and their type/severity.
n
Network - Shows Internet information and wireless network/radio status.
If applicable, click the links to configure Internet and Wireless options.
n
Statistics - Shows live data graphs of packet rate and throughput.
To monitor your device's internet connection from your mobile device, you must first configure
this on the WebUI Home >System page.
To configure connection monitoring:
1. In the WebUI, go to Home >System > Internet connections and click Edit.
The Edit Internet Connection window opens.
2. In the Connection Monitoring tab, check or clear:
n
Automatically detect loss of connectivity to the default gateway. This pings the
default gateway to detect if connectivity is lost.
n
Monitor connection state by sending probe packets to one or more servers on
the Internet. This uses other methods and servers to detect connectivity loss.
Important - In versions R81.10.10 and higher, it is supported to disable
probing in an Internet connection only if you clear the option, "This Internet
connection will be a part of SD-WAN" (on the "Advanced" tab > section
"SD-WAN Settings").
3. If you selected Monitor connection state, select the connection probing method: