Working with User Awareness
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|258
l
You can configure the Browser-Based Authentication to appear for all traffic. This
identification method is commonly configured to appear when you access only
specific network resources or the Internet to avoid the overhead required from end
users when they identify themselves.
l
For traffic that is not HTTP based, you can also configure that all unidentified users
are blocked from accessing the configured resources or Internet until they identify
themselves first through the Browser-Based Authentication.
n
Identity Collector - Collects information about identities and their associated IP
addresses and sends it to the Security Gateway for identity enforcement.
Note - In the R81.10.X releases, this feature is available starting from the
R81.10.05 version.
Enabling User Awareness
1. Select the On or Off option.
Note - When the blade is managed by Cloud Services, a lock icon is shown.
You cannot toggle between the on and off states. If you change other policy
settings, the change is temporary. Any changes made locally are overridden in
the next synchronization between the gateway and Cloud Services.
2. Click the Configuration wizard link.
The User Awareness Wizard opens.
3. Select one or more user identification methods and click Next.
4. Follow the rest of the steps and click Finish.
5. After initial configuration, you can select the Active Directory Queries or Browser-
Based Authentication checkboxes under Policy Configuration and click Configure to
configure more advanced settings.
Active Directory Queries:
If you have an existing Active Directory server, click Use existing Active Directory servers.
To add a new Active DirectoryDomain:
1. Select Active Directory Queries and click Configure.
The Active Directory Queries window opens.
2. Select Define a new Active Directory server.
3. Enter:
To Next Page
Loading...
