Quantum SPARK 1500 - Configuring VPN; Configuring Remote Access VPN; Introduction; Prerequisites

Configuring VPN
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|303
Configuring VPN
This section describes how to configure these VPN configuration scenarios:
n
Remote Access VPN
n
Site to Site VPN using a preshared secret
n
Site to Site VPN using a certificate
Note - VPN does not work with pure IPv6, only with dual IP stack.
Configuring Remote Access VPN
Introduction
Use these options for remote access:
n
Check Point VPN clients
n
Check Point Mobile clients
n
Check Point SSL VPN
n
L2TP VPN client
Prerequisites
n
In VPN > Blade Control, make sure:
l
To set the Remote Access control to On.
l
To select the Allow traffic from Remote Access users (by default) option.
l
To select the applicable connection methods.
For more details, see "Configuring the Remote Access Blade" on page309 .
n
If the gateway uses a dynamic IP address, we recommend you use the DDNS feature.
See "Configuring DDNS and Access Service" on page162 .
n
For the Check Point VPN client or Mobile client method, make sure that the applicable
client is installed on the hosts. Click How to connect for more information.