Quantum SPARK 1500 - Configuring VPN Sites

Configuring VPN Sites
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|340
Configuring VPN Sites
In the VPN > Site to Site > VPN Sites page you can configure remote VPN sites. All
configured VPN sites appear in the table.
For more on how to configure site to site VPN, go to VPN > Site to Site > Blade Control.
When you add a new VPN site, these are the tabs where you configure these details:
n
Remote Site - Name, connection type, authentication method (preshared secret or
certificate), and the Remote Site Encryption Domain.
n
Encryption - Change the default settings for encryption and authentication details.
n
Advanced - Enable permanent tunnels, disable NAT for this site, configure encryption
method, and additional certificate matching.
To add a new VPN site:
1. Click New.
The New VPN Site window opens in the Remote Site tab.
2. Enter the Site name.
3. Select the Connection type:
n
Host name or IP address - Enter the IP address or Host name.
If you select IP address, and it is necessary to configure a static NAT IP address,
select Behind static NAT and enter the IP address.
Note - Behind static NAT applies to IPv4 addresses only.