Setting Up the Quantum Spark Appliance
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|23
Note - Wait 10 seconds between power cycles (off and on).
Using Default WiFi
Starting in version R81.10.07, you can use the default SSID for a WiFi connection.
Note -
n
This option is only available when connecting the appliance for the first time and
the First Time Configuration Wizard did not yet run.
n
Only available for one hour.
1. Connect the appliance cable and the WAN cable.
2. Use the SSID and password printed on the appliance sticker to connect to WiFi.
Note - Skip this step if you are connecting through LAN.
3. Browse to default gateway IP address: https://192.168.1.1:4434
The Welcome screen of the First Time Configuration Wizard appears.
4. Click Fetch Settings from the Cloud.
5. In the new window, click Yes to confirm that you want to proceed.
6. The Internet connection page of the First Time Configuration Wizard
7. From the Connection type drop-down menu, select Static IP.
8. Click Connect.
The One Touch status bar is running.
Note - If you were connected to WiFi: After the One Touch script finishes running, the
WiFi network you were connected to is deleted. As a result, you are disconnected
from the appliance.
To Next Page
Loading...
