Quantum SPARK 1500 - Configuring Administrator Access

Configuring Administrator Access
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|154
Configuring Administrator Access
On the Device > System > Administrator Access page you can:
n
Configure the IP addresses and interface sources that administrators can use to access
the Quantum Spark Appliance.
n
Enable Two-Factor Authentication (2FA) to add an extra layer of security on the
gateway.
n
Configure the Web and SSH ports.
To set the interface sources from which administrator access is allowed
Select one or more of these options:
n
LAN - All internal physical ports
n
Trusted wireless - Wireless networks that are allowed access to the LAN by default
(only in Wireless Network models.)
n
VPN - Uses encrypted traffic through VPN tunnels from a remote site or uses a remote
access client
n
Internet - Clear traffic from the Internet (not recommended to allow access from all IP
addresses)
To allow administrator access from any IP address
1. Select the Any IP address option. This option is less secure and not recommended.
We recommend you allow access from the Internet to specific IP addresses only.
2. Change the WEB Port (HTTPS) and/or SSH port if necessary.
3. Click Save.
An administrator can access the Quantum Spark Appliance using any IP address
through the allowed interface sources.
To allow administrator access from specified IP addresses
1. Select the Specified IP addresses only option.
2. Click New.
The IP Address Configuration page appears.
3. Select Type: