Quantum SPARK 1500 - Page 155

Configuring Administrator Access
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|155
n
IPv4 address
n
IPv4 network
n
IPv6 address
n
IPv6 network
4. Enter the IP address or click Get IP from My Computer.
5. Click Save.
The IP address is added to the table.
6. Change the WEB Port (HTTPS) and/or SSH port if necessary.
7. Click Save.
An administrator can use the configured IP addresses to access the appliance
through the allowed interface sources.
To allow administrator access from both specified and any IP addresses
Select this option when it is necessary to allow administrator access from the Internet (you
must define the specified IP addresses). Access from other sources is allowed from any IP
address.
1. Select the Internet source checkbox.
2. Select the Specified IP addresses from the internet and any IP address from other
sources option.
3. Click New.
The IP Address Configuration page shows.
4. Select Type:
n
IPv4 address
n
IPv4 network
n
IPv6 address
n
IPv6 network
5. Enter the IP address or click Get IP from My Computer.
6. Click Save.
The IP address is added to the table.
7. Change the WEB Port (HTTPS) and/or SSH port if necessary.