Zero Touch Cloud Service
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|25
Zero Touch Cloud Service
The Zero Touch Cloud Service lets you easily manage the initial deployment of your gateways
in the
Check Point Zero Touch Portal
.
Note - You cannot use Zero Touch if you connect to the Internet through a proxy server.
Zero Touch enables a gateway to automatically fetch settings from the cloud when it is
connected to the internet for the first time.
Note - The appliance is fully configured after you complete the First Time
Configuration Wizard (click Finish on the final screen or click Quit on an earlier
screen after you enter a username and password). To use the Zero Touch Cloud
Service after this point, you must first restore the factory defaults.
If the gateway connects to the internet using DHCP, the gateway fetches the Zero Touch
settings without any additional action. If no DHCP service is available, you must run the First
Time Configuration Wizard, configure the Internet Connection settings, and then fetch the
settings from the Zero Touch server.
Note - You can run the Zero Touch configuration on DMZ over the SFP port. Connect
the cable to the DMZ/SFP port as for WAN.
To connect to the Zero Touch server from the First Time Configuration Wizard:
1. In the Welcome page of the First Time Configuration Wizard, click Fetch Settings from
the Cloud.
2. In the window that opens, click Yes to confirm that you want to proceed.
3. The Internet connection page of the First Time Configuration Wizard opens. Configure
your Internet connection and click Connect.
4. The settings are automatically downloaded and installed.
5. A new window opens and shows the installation status. It may take several minutes until
the installation is complete.
Note - If a collision is detected between an internal network (LAN) and an IP returned
via DHCP (WAN), the conflicting LAN address is changed automatically. If a colliding
LAN IP address is changed, a message appears in the system logs.
When you reconnect to the WebUI or click Refresh, the browser opens to show the status of
the installation process.
After the gateway downloads and successfully applies the settings, it does not connect to the
Zero Touch server again.
To Next Page
Loading...
