Quantum SPARK 1500 - Smart Accel for Assets

Inspecting VoIP Traffic
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|252
Wait for the toggle to change to Off.
Smart Accel for Assets
Note - In the R81.10.X releases, this feature is available starting from the R81.10.05
version.
To enable Smart Accel for Assets
Note - Smart Accel for Assets is disabled ("Off") by
default.
1. Go to the Access Policy view > Firewall section > Smart Accel page.
2. In the section Smart Accel Assets, click the Off toggle.
Wait for the toggle to change to On.
3. To the right of the On/Off toggle, click the assets link that appears in one of these
sentences:
n
All assets selected
n
X/Y assets selected
The Smart Accel Services window opens.
By default, none of the assets are selected.
4. If it is necessary to inspect an asset, then clear its checkbox.
If it is necessary to bypass the inspection for an asset, then select its checkbox.
5. Click Apply
To disable Smart Accel for Assets
1. Go to the Access Policy view > Firewall section > Smart Accel page.
2. In the section Smart Accel Assets, click the On toggle.
Wait for the toggle to change to Off.
To see devices, for which Smart Accel bypasses the inspection
1. Go to the Access Policy view > Firewall section > Smart Accel page.
2. In the section Smart Accel Assets, click the Bypass by MAC link.
3. WebUI opens the Logs & Monitoring view > Status section > Active Devices page.