Configuring Cloud Services
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|43
Configuring Cloud Services
On the Home > Cloud Services page, you can connect the appliance to Cloud Services.
The Cloud Services Provider uses a Web-based application to manage, configure, and
monitor your appliance.
To connect the appliance to Cloud Services:
1. Click the activation link in the email that the Security Gateway owner gets from the Cloud
Services Provider.
2. Log in.
A window opens and shows the activation details sent in the email.
3. Make sure the activation details are correct and click Connect.
If the appliance is connected to a different Cloud Services Provider, you are asked if you want
to continue.
Alternatively, follow the connection procedure below.
When you successfully connect, a security policy and other settings are pushed to the
appliance. The settings defined by Cloud Services contain your activated blades, security
policy, and service settings.
After Cloud Services are turned on, these identification details are shown in the WebUI:
n
At the bottom of the login page - The name defined by the Cloud Services Provider for
your Security Gateway and the MAC address of the Quantum Spark Appliance.
n
At the top of the WebUI application (near the search box) - The name of your Quantum
Spark Appliance.
These are the sections on this page:
n
Cloud Services - This section shows Cloud Services details.
l
The Configure option lets you configure initial connectivity.
l
When connected, you can click Details to see connectivity details and Fetch now
to get updated activated blades, security policy and service settings.
l
When disconnected, you can click Refresh to try and reconnect to Cloud Services.
n
Managed Security Blades - Shows a colorful or black and white icon for defined security
blades. You can click the icon text to open the corresponding page in the WebUI.
To Next Page
Loading...
