Configuring MAC Filtering
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|135
To disable 802.1x authentication on an interface:
1. Go to Device > Local Network.
Select the LAN interface and click Edit.
2. The Edit window opens in the Configuration tab.
3. Click the Advanced tab.
4. Clear Activate 802.1x authentication.
5. Click Apply
To configure logging for MAC filtering and 802.1x authentication:
1. Go to Device > Advanced Settings.
2. Set the value of the MAC Filtering settings - Log blocked MAC addresses attribute to
n
Enabled - To enable logging
n
Disabled - To disable logging.
Note - This attribute is available only in Locally Managed mode. In Centrally
Managed mode, configure logging with CLI.
3. Optional -
n
To reduce the number of logs, specify the value of the MAC Filtering settings -
Log suspension attribute in seconds.
n
To show all logs, set the value to "0".
Note - Traffic dropped in the WiFi driver is not logged.
To Next Page
Loading...
