Quantum SPARK 1500 - Page 146

Configuring Local and Remote System Administrators
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|146
To create a local administrator:
1. Click New.
The Add Administrator page opens.
2. Enter the administrator details:
Note - To enable Two-Factor Authentication (available starting from the
R81.10.10 release), all administrators must have both an email address and
a phone number configured. Click Test to verify that you can receive
messages at both the email address and phone number.
n
Name. The hyphen (-) character is allowed in the administrator name.
n
Password and then Confirm password.
Note - You cannot use these characters in a password or shared
secret: { } [ ] ` ~ | ‘ " \ (maximum number of characters:
255)
n
Email address.
Note - In the R81.10.X releases, this feature is available starting from
the R81.10.05 version.
n
Phone number. - Include the country code and do not include “+” at the
beginning of the phone number. For example, "44123456789" where "44" is the
country code.
Note - In the R81.10.X releases, this feature is available starting from
the R81.10.05 version.
3. Click Save.
The name and Administrator Role is added to the table. When logged in to the WebUI,
the administrator name and role is shown at the top of the page.
Note - If Two-Factor Authentication is not enabled, defining an email address and
phone number is optional. However, you must have either an email address or a
phone number defined to:
n
Receive Security alert notifications by email or SMS. See "Notifications" on
page49
n
To reset your password on the Login page of the WebUI (see below).